The Link G4+ range of engine management systems are already well known for delivering class-leading performance without sacrificing factory levels of drivability.
The G4x takes this a step further with massively enhanced logging, mapping, maths and channel configuration.
The Link G4X Xtreme, With 8 injector drives & 8 ignition drives, this ECU is perfect for almost any engine with up to 8 cylinders. The Xtreme can also run engines with up to 12 cylinders using group-fire injection
Alongside the XtremeX, the bundle includes 2.5 m A and B looms, a CAN Lambda wideband controller with a Bosch LSU 4.9 sensor, a Link 4 bar MAP sensor and an intake air temperature (IAT) sensor with a 1/8" NPT thread.
The CAN Lambda is essential for modern tuning, giving you fast and accurate live Lambda without using up any DI or An Volt inputs. Each sensor comes with its Deutsch DTM connector kit, and the 4 bar MAP sensor suits turbo or supercharged engines running up to 3.0 bar (44 psi) of boost.
Inputs
8/10* x Digital inputs
4 x Temperature inputs
11 x Analog inputs
2 x Trigger inputs
2 x Knock inputs
*2 inputs required when using 2nd CAN Bus
Outputs
8 x Peak and Hold injection drives
8 x Ignition drivers
10 x Auxiliary outputs^
+5V Sensor power supply
+8V Sensor power supply
^unused fuel and ignition drives can be used as additional Aux outputs
Communications
2* x CAN bus
1x Serial (RS232) connection
1x USB tuning connection
Faster communications than G4+ models
512 Megabytes Data Logging
Physical
Dimensions: 185mm(L) x 130mm(W) x 40mm(H) (without looms)
Mass: 680grams
Advanced features not found on the Storm:
Fully programmable E-throttle control complete with capability of gear shift throttle blip and antilag.
Cruise control.
Two independent CAN modules.
30 general purpose tables (up from 20)
All Motorsport features including full gear shift control, cruise control, traction control, antilag and launch control.
Advanced closed loop lambda strategy and dual bank lambda control.
What's in the box?
Supplied with USB tuning cable and mounting bracket.
Requires “A” & “B” looms or “A” & “B” connector kits.